1. Core Advantages - Three Moulding Logics
The mould sets the rules. Draft 1–1.5° (plus 0.5–1° for glass-filled resin), walls kept 1.5–3.0 mm and uniform, ribs at 50–60% of wall - geometry that ejects cleanly is geometry that repeats.
One part replaces an assembly. Brackets, bosses and mounting points moulded in one shot, with metal threads inserted during moulding - fewer parts, fewer screws, fewer failure points.
Volume pays for the tool. Tooling is a one-time cost; moulding economics flip at a certain batch size. Below that, we tell you so instead of selling a mould you don't need.
We mould structural parts to your drawing; load rating, fatigue life and device-level certification belong to the robot builder.
JBRplasqhpmould.com
2. Parameter Table (Typical Values)
| Parameter | Typical value |
|---|---|
| Material | PA66-GF30 (PA66 + 30% glass) |
| Tensile strength | ~180 MPa dry (vs ~80 unfilled) |
| Flexural modulus | ~8.5 GPa (vs ~2.8 unfilled) |
| HDT @1.8 MPa | ~250 °C |
| Wall thickness | 1.5 – 3.0 mm, uniform |
| Draft angle | 1 – 1.5° (+0.5–1° glass-filled) |
| Tolerance | ±0.1 – 0.3 mm typical |
| Inserts | Metal thread insert moulded in |
| Tool life | shots |
Typical material data; part tolerance and tool life confirmed per drawing and mould design.
3. Customization - Drawing to Part
DFM review on your STEP before quoting - wall, draft and rib feedback.
Material choice - PA66-GF30/35, PA6, PPS or antistatic grades.
Insert moulding - metal threads, bushings, wear plates.
T1 samples for fit check before production.
4. Company Advantages - Export
Mould + moulding in one house. No tooling hand-off between vendors.
Export documents ready. Commercial invoice, packing list, HS code per order.
Flexible shipping. Express for T1 samples, sea freight for production.
Where we ship. Supplying [exoskeleton builders /robotics OEMs] in [US / EU / Asia ]; certifications .
5. FAQ
Q: Who owns the mould? Negotiable - customer-owned or ours; stated in the quotation, not assumed.
Q: What is the minimum batch? Moulding becomes economic above a threshold that depends on part size and tool; we quote both routes so you can compare.
Q: Why not carbon fiber for this part? Carbon suits low volume and maximum stiffness; moulding suits complex geometry at volume. For a joint housing in the thousands, moulding usually wins on cost.
Q: Can you take the load rating? No - we mould the part to your drawing; load rating and fatigue are validated by the robot builder.
Q: Shipping time? T1 samples in 5-15 days after tool; production quoted per volume.
Hot Tags: injection molded exoskeleton robot structural parts - joint housing component, China injection molded exoskeleton robot structural parts - joint housing component manufacturers, suppliers, factory

